User guide

23
Installing the Smart Wi-Fi Gateway
Installing the MF7211-Outdoor Model
If You Are Mounting the Device Outdoors
WARNING: The Ruckus Wireless PoE injector and power adapter are for indoor use
only. Never mount the PoE injector outdoors with the Smart Wi-Fi Gateway.
If you are mounting the Smart Wi-Fi Gateway outdoors, Ruckus Wireless strongly
recommends that you perform these additional tasks:
• Install the Side Panel Cover
• Mount the Device
Install the Side Panel Cover
The Smart Wi-Fi Gateway is shipped with its side panel cover removed. Before you
mount the device outdoors, install the side panel cover (see Figure 14.
).
1. Make sure that the perimeter rubber gasket on the housing is clear of debris.
2. Place the cover onto the cavity on the side panel.
3. Fasten the side panel cover to the chassis using the two gasketed machine screws
that are supplied with the device, and then install a silicone screw cap over each
screw to seal the opening.
Mount the Device
Use the two mounting slots on the rear panel to mount the unit on a wall or to a pole.
• To mount the unit on a wall, install two screws on the wall surface, and then use
one of the mounting holes on the
• To mount the unit to a pole, insert tie-wraps into the mounting holes, and then
fasten them to the pole.
CAUTION: The unit must be mounted in the upright position to ensure that the hole
at the bottom can drain out water that may enter the unit. See Figure 14
.