User guide

19
Installing the Smart Wi-Fi Gateway
Installing the MF7211-Outdoor Model
Step 2: Connect the Device to a Power Source and
the Admin Computer
CAUTION: Use only the PoE injector and power adapter that are supplied with this
device.
1. Take out the PoE injector and power adapter that were shipped with the device.
2. Connect the power jack to the 12VDC port on the PoE injector, and then connect
the power adapter to a power source or to a surge protector that is plugged into
a power source.
Figure 10.Connect the Ethernet cables and power adapter to the PoE injector
3. Take one of the CAT5 Ethernet cables. Connect one end of the CAT5 Ethernet
cable to the Ethernet port on your computer, and then connect the other end to
the NETWORK 10/100 port on the PoE injector.
4. Take the other Ethernet cable. Connect one end to the WIRELESS AP/BRIDGE
port on the PoE injector, and then connect the other end to the Ethernet port on
the device (see figure).