User`s guide

USM-Metro-RKS1-091807-01 Ruckus Metro Broadband Gateway 19
Connect and Configure the Metro Broadband Gateway
Connect and Configure the Metro Broadband Gateway
The following steps will guide you to set up and gain administrative access to your Ruckus Metro Broadband
Gateway.
1. Remove the Ruckus Metro Broadband Gateway from the packaging and place it next to your computer.
2. Connect the AC power supply to the Metro Broadband Gateway and plug the other end into a power outlet
or to a surge protector that is plugged into a power outlet.
3. Connect the CAT5 Ethernet cable to the Ethernet port on your computer, and to the Ethernet port on the
Ruckus Metro Broadband Gateway.
4. On your PC, open a browser window. Type the IP address as noted on the bottom of the device.
5. When the login screen appears, type the username and the password as noted on the bottom of the device.
6. Click the Login button.
NOTE – If your Metro Broadband Gateway is not properly configured, you will see the captive portal page.
Upon initial login, you will see the initial configuration options page.
Figure 14—Ruckus Wireless Web Interface Wizard options screen
7. On the initial configuration welcoming page, there are two options:
• YES I want to use the wizard. To continue with the wizard, go to Step 8.
• NO I want to configure it manually. To configure manually, refer to Chapter 3:, “Status and
Configuration.
8. Click YES I want to use the wizard.
4Gon www.4Gon.co.uk [e-mail] Tel: [phone] Fax: [phone]