Operation Manual

Opening and closing the latch:
The latch can be opened using the enclosed handles.
Maintenance
• When the ceramic burner has been used very often, discolorations on the top can occur. This is normal and does no harm to the
quality of the product.
• Do not use an abrasive product for cleaning the insert. Clean the surfaces with a moist piece of cloth or a non-abrasive stainless
steel cleanser.
• Glass screens can be cleaned with a ceramic cook top cleaner.
Possible problems and solutions:
Changes and/or alterations to the insert, surface or burner are unacceptable and will cause the warranty to expire.
Ruby Fires cannot be held responsible for possible damages or personal injuries caused by misuse or incompetent use of the insert
and ceramic burner.
Important:
• The ceramic burner is to be used for decorative purposes only and not as a primary source of heating.
• Bio ethanol is a hazardous material of dangle level UN 1987, level 3
• The use of the ceramic burner as a multi-burner or open fi re for liquid or solid combustible materials is not permitted.
• The ceramic burner is to be extinguished using the latch on the topside.
• When the ceramic burner is overfi lled there is a risk of spilling the liquid fuel e.g. when it is bumped into. This can cause uncontrolla-
ble fl ames.
• The fl ames cannot be adjusted by using the latch. This should always be completely opened when in use.
• Do not smoke while (re)fi lling or lighting the burner. Risk of explosion!
• Never change the construction of the ceramic burner.
• Warning! Never re-fi ll a hot or warm ceramic burner. Risk of explosion!
• The fl ames should never directly touch the inside of the metal insert.
• Avoid physical contact with the bio ethanol.
• It is prohibited for children, people under the infl uence of alcohol, drugs or medications, or people who are physically or mentally not
in good condition, to use the Ceramic Burner.
• Keep children and pets at a safe distance.
Problem Possible cause Solution
Existence of soot Wrong fuel Use ONLY Ruby Fires bio ethanol 98%
Existence of soot Fire-opening is covered with decoration material Make sure the fi re-opening is free of decoration material
Duration of fi re too short Wrong fuel (e.g. gel) Use ONLY Ruby Fires bio ethanol 98%
Duration of fi re too short Burner has not been fi lled completely Extinguish the burner. Let it cool down for at least
30 minutes and then re-fi ll.
Flames too high Wrong fuel or draft Use ONLY Ruby Fires bio ethanol 98%
Flames too low, not visible Burner has not been fi lled completely Extinguish the burner. Let it cool down for at least
30 minutes and then re-fi ll.
Burner makes a rustling noise Wrong fuel (e.g. gel) or overfi lled Use ONLY Ruby Fires bio ethanol 98%
Flames are blue, not visible Fuel is almost fi nished Extinguish the burner. Let it cool down for at least
30 minutes and then re-fi ll.
Flames remain after the Open the latch and quickly close it again to refrain
latch has been closed the oxygen supply