Installation Instructions

Guidelines for building in Ruby Fires ceramic bio ethanol burners
General guidelines:
• Ruby Fires ceramic burners are decorative fires and
not primarily a heating appliance as such.
• For indoor use only.
• Do not use in places where there is a lot of draft.
• Make sure there is enough ventilation in the room.
• Bio ethanol is a highly flammable liquid and needs to
be handled with care.
• Materials around the burner can heat up. (risk of burn marks)
• Only to be used by adults of 18 years or older.
• Keep children and pets at a safe distance of the fire.
• Make sure that all gas pipes in the surroundings are disconnected.
• Use LEF bio-ethanol (or an bio-ethanol with the same composition) and original Ruby Fires
decoration materials only.
Minimum room size:
Type burner
Mi
nimum room size
Air refreshment
4114
75 m3
Make sure there is sufficient ventilation by
means of a ventilation hole or window
and/or a crack underneath a door. On two
locations opposite to each other.
4120
75 m3
5820
105 m3
8014L
120 m3
INSTRUCTIONS FOR BUILDING IN INSERTS
Cut out dimensions:
Bio insert small 660 mm x 420 mm x 230 mm (hxwxd)
Bio insert large 660 mm x 600 mm x 230 mm (hxwxd)
Bio insert XL 490 mm x 890 mm x 230 mm (hxwxd)
(with a strip of 910 mm at the bottom)
Bio insert XXL 490 mm x 1210 mm x 230 mm (hxwxd)
(with a strip of 1240 mm at the bottom)
Instructions for building in inserts:
• When making a gap for building in an insert, make sure that any material,
which is in direct contact with the insert, is heatproof (see examples of
permitted building materials).
• There should be 50 mm of open space on each side of the insert, which is
to be filled up with insulation material (see examples of permitted
building material).
• Place the insert in the gap and make sure the insert is levelled.
• Secure the insert to the wall through the screw holes in the flange.
• Make sure that the screws are fastened tightly.
• Finish the flange if desired with non-combustible material (see examples
of permitted building material)
• Place the Ruby Fires ceramic burner in the insert.
Ruby Fires build in insert
• Place the connectors and the glasses on the burner.
• If applicable place the decoration material such as pebbles and/or ceramic logs around the
burner opening. Make sure the decoration material is not in direct contact with the flames.
Ruby Fires bio
-
ethanol burner