Use and Care Manual

Updated 4/1/2016

 Verify substrate is free of bond-inhibiting or bond-breaking materials such as curing

compounds and dust.

 Repair all cracks and seal surface from running water and contaminants prior to

application

 Do not apply over unprimed galvanized steel.

 Contact Technical Services for applications where the product will be exposed to

chlorinated water.

Suitable Substrate

► Sound, Stable Concrete ► Woods and Plastic

► Tiles ► Bricks

► All Metals ► Glass

► Exterior Grade plywood, shiplap, tongue and groove.

► Veneer, plastic laminate, Glue-laminate Wood.

► Masonry Block free from dirt (Parged where required by local codes)

► Foamglas® Block



Consult Inflow Solutions LLC Technical Services Department for installation recommendations

regarding any substrates and conditions not listed.

Substrate Preparation

 All substrates must be structurally sound, dry, solid and stable. The surface shall be

clean of dirt, oil, and grease and free of loose impediments.

 The surface may be damp (not wet). However any running water must be sealed or

contained through relief pipes that are commonly used in grouting work.

 Mechanically clean the area to be sealed (use a stiff wire brush or equivalent)

 Complete structural repairs to substrate prior to application of the Rubberseal™ Roll-On

or Trowel.

 When applying over existing installations of Rubberseal™ Spray Grade, thoroughly

wash the area of application with fresh water, and wipe dry before applying the material.

Mixing

Rubberseal™ Roll Grade must be thoroughly mixed using a paddle mixer at SLOW (approx.

100 RPM) speed. Caution: Mixing at medium or high speed may cause separation of the polymer, creating

small chunks of material in the product. Mix for 5 minutes prior to installation, until material is entirely

homogenous (any film will return to solution with mixing).

If material sits more than 3 hours, remix for 5 minutes. Do not add water, solvents, or any other

materials to the product.

*****Rubberseal™ Trowel Grade does not require mixing prior to use.*****

Note: Choose all appropriate safety equipment before use. Refer to MSDS for more information.

PRODUCT APPLICATION

Roll Application – Rubberseal™ Roll Grade may be applied using a standard 3/8” (8mm) nap

roller with standard cage in small areas. When applying over large areas, ensure that a dual

mount caged roller is used. Roll material onto concrete and spread evenly to achieve a thorough

depth and film consistency of at least 15 mil WFT (wet film thickness) on the first coat.

Once dry, apply additional coats to realize > 30 mil DFT (dry film thickness) for damp-proofing

applications, and >60 mils DFT for waterproofing applications. Damp-proofing applications, and

>60 mils DFT for waterproofing applications. Ensure no voids are present in the application.