Instructions / Assembly

ManualsBrandsRubbermaid ManualsGarage StorageFastTrack Garage Wall Storage Slat Panel System Paper Towel Holder

2001934

Rubbermaid Incorporated,

Huntersville, NC U.S.A. 28078-1801

U.S.A. 1-888-895-2110

Canada 1-866-595-0525

www.rubbermaid.com

7W98 – Paper Towel Holder

Assembly Steps

PKG0000638737

STEP 1

NO TOOLS

REQUIRED

ATTACH PAPER TOWEL HOLDER TO

INSTALLED WALL PANEL

NOTE: You will need no less than two wall

panels installed vertically, creating three full

grooves for installation. Ensure the wall panel

is properly installed using the instructions

supplied with the wall panel.

Insert top metal tab into wall panel groove (1)

and push top tab upward into the slot and rotate

downward (2). Rotate until the bottom tab

enters the bottom groove and the unit is ﬂush

with the wall panel (3), slide entire unit straight

down until the bottom tab locks the unit onto

the wall panel (4).

CAUTION: Do not use excessive force.

Summary of content (6 pages)

PAGE 1
7W98 – Paper Towel Holder Assembly Steps 2001934 Rubbermaid Incorporated, Huntersville, NC U.S.A. 28078-1801 U.S.A. 1-888-895-2110 Canada 1-866-595-0525 www.rubbermaid.com NO TOOLS REQUIRED STEP 1 ATTACH PAPER TOWEL HOLDER TO INSTALLED WALL PANEL NOTE: You will need no less than two wall panels installed vertically, creating three full grooves for installation. Ensure the wall panel is properly installed using the instructions supplied with the wall panel.
PAGE 2
STEP 2 INSTALL PAPER TOWEL ROLL ONTO PAPER TOWEL ROD NOTE: Paper towels sold separately. Remove paper towel rod. (1) Lift rod upward, (2) pull rod forward, (3) pull down rod to remove. Insert paper towel rod into paper towel roll. Position paper towel roll between the rotation knobs. 2 3 1 2 3 1 STEP 3 INSTALL PAPER TOWEL ROD INTO PAPER TOWEL HOLDER Insert paper towel rod leaving the rotation knobs to the outside of the unit. 1. Move rod upward into the holder groove. 2.
PAGE 3
7W98 – Étapes de montage du porte essuie-tout 2001934 Rubbermaid Incorporated, Huntersville, NC, États-Unis 28078 - 1801 U.S.A. 1-888-895-2110 Canada 1-866-595-0525 www.rubbermaid.com AUCUNS OUTILS NÉCESSAIRES ÉTAPE 1 FIXER LE PORTE ESSUIE-TOUT AU PANNEAU MURAL INSTALLÉ REMARQUE : Au moins deux panneaux muraux doivent être installés verticalement afin de créer trois rainures complètes pour l’installation.
PAGE 4
ÉTAPE 2 INSTALLER LE ROULEAU D’ESSUIE-TOUT DANS LA TIGE DU PORTE ESSUIE-TOUT REMARQUE : Les essuie-tout sont vendus séparément. Retirez la tige de l’essuie-tout. (1) Levez la tige vers le haut, (2) tirez la tige vers l’avant, (3) poussez la tige vers le bas pour la retirer. Insérez la tige du porte essuie-tout dans le rouleau d’essuie-tout. Positionner le rouleau d’essuie-tout entre les boutons de rotation.
PAGE 5
7W98 – Pasos para el armado del portarrollos de toallas de papel 2001934 Rubbermaid Incorporated, Huntersville, NC U.S.A. 28078-1801 Estados Unidos 1-888-895-2110 Canadá 1-866-595-0525 www.rubbermaid.com SIN NECESIDAD DE HERRAMIENTAS PASO 1 FIJAR EL PORTARROLLOS DE TOALLAS DE PAPEL AL PANEL INSTALADO EN LA PARED NOTA: Necesitará, como mínimo, dos paneles de pared instalados en posición vertical, formando tres ranuras completas para la instalación.
PAGE 6
PASO 2 INSTALAR EL ROLLO DE TOALLAS DE PAPEL EN LA BARRA NOTA: Las toallas de papel se venden por separado. Retire la varilla de la toalla de papel. (1) Levante la varilla, (2) jale hacia adelante, (3) jale hacia abajo la varilla para retirarla. Insertar la barra en el rollo de toallas de papel. Colocar el rollo de las toallas de papel entre las perillas de rotación.