LinkPro Installation Instructions Copyright 2019 US SHADE CORPORATION Rev B | April 2019
INITIAL CONSIDERATIONS Thank you for your purchase of LinkPro. This is a WiFi to RTS gateway which operates at 433.42MHz. Minimize or eliminate any sources of RF interference and shielding. Any metal, wire, or foliage near the product can reduce or block the signal reducing the operating range of the device. Other nearby transmitters may also cause interference. Thank you for purchasing an SI product. If you have any questions or need any assistance with your LinkPro, we would love to help you.
PARTS IN THE BOX • (1) LinkPro Unit • (1) Original Mounting Ring • (1) Magnetic Mounting Ring - Pre-installed • (2) 48v Passive PoE Injector • (1) Injector Power Cable • (1) 5 Meter Cat5 • (1) 2 Meter Cat5 • (2) Drywall Anchor • (2) Wall Mounting Screws (PH2) • (2) Top Mounting Screws (PH2) • (1) Quickstart Guide 2 LinkPro - Parts in the Box 3
INSTALLATION - CEILING/WALL MOUNT or MAGNETIC MOUNT 3. Drill a 3/4” hole in the center of the space illustrated for the Ethernet cable. 1. Position the Wall/ Magnetic mounting bracket in the desired location in the orientation illustrated. up Magnetic Mounting Ring Wall Mounting Ring 3/4" hole for Ethernet cable NOTE: Wall Mount installation process is similar as Magnetic Mount. For more details contact support. 2.
4. Gently drive the drywall anchors into the 7/32" holes. Locate your Cat5 wire and run it throgh the hole drilled. 6. Plug in the LinkPro and align the magnets on the back of the device with two of the recessed areas illustrated below. The magnets should fit snug in the recessed areas, and the device should be flush against the bracket. 5. Mount the bracket to the ceiling using the provided Phillips screws in the orientation illustrated. LinkPro - Installation 6 LinkPro - Installation (cont.
7. There should be an audible click. LinkPro - Installation 8 LinkPro - Installation (cont.
RESET 8. Now connect the other end of your Cat5 to PoE switch (sold seperately)/ PoE injector (incl.) Use a thin tool (eg. paperclip) to hold down the reset button on the side of the LinkPro (LED will turn red) for approximately 20 seconds, or until the LED turns off.
SET UP NOTE: Before proceeding, ensure all Nano shades are installed and programmed along with group and limit settings. 1. Download Somfy’s myLink application from the App Store or Google Play. 2. Power your LinkPro using a PoE switch or the provided PoE injector, and wait until the LED on the LinkPro turns solid red. 3. Follow the in-app instructions to connect your LinkPro (referred to as myLink in the application) to the wireless network. 5.
www.screeninnovations.com/accessories/linkpro FCC INFORMATION This device complies with Part 15 of the FCC Results. Operation is subject to the following two conditions: 1. This device may not cause harmful interference, and 2. This device must accept any interference received, including that which may cause undesired operation. NOTE: This equipment has been tested and found to comply with the limits for CLASS B digital device, pursuant to Part 15 of FCC Rules.
