System Guide

SME VOIP SYSTEM GUIDE 4.7 7 | P a g e
Proprietary and Confidential
1 About This Document
This document describes the configuration, customization, management, operation, maintenance and troubleshooting
of the SME VoIP System (RTX9431 base, RTX8630 handset, RTX8430 handset, RTX8830 ruggedized handset and
RTX4024 Repeater) in RTX generic mode. For customer, specific modes refer to specific customer agreements, which
describe the software operational deviations from this document.
1.1 Audience
Who should read this guide? First, this guide is intended for networking professionals responsible for designing and
implementing RTX based enterprise networks.
Second, network administrators and IT support personnel that need to install, configure, maintain, and monitor
elements in a “live” SME VoIP network will find this document helpful. Furthermore, anyone who wishes to gain
knowledge on fundamental features in the Beatus system can also benefit from this material.
1.2 When Should I Read This Guide
Read this guide before you install the core network devices of VoIP SME System and when you are ready to setup or
configure SIP server, NAT aware router, advanced VLAN settings, base stations, and multi cell setup.
This manual will enable you to set up components in your network to communicate with each other and deploy a fully
functionally VoIP SME System.
1.3 Important Assumptions
This document was written with the following assumptions in mind:
1) You understand network deployment in general
2) You have working knowledge of basic TCP/IP/SIP protocols, Network Address Translation, etc…
3) A proper site survey has been performed, and the administrator have access to these plans
1.4 What’s Inside This Guide
We summarize the contents of this document in the table below:
WHERE IS IT?
CONTENT
PURPOSE
CHAPTER 2
Introduction – System Overview
To gain knowledge about the different elements in a typical
SME VoIP Network
CHAPTER 3
Installation of Base
station/Repeater
Considerations to remember before unwrapping and
installing base units and repeaters
CHAPTER 4
Making Handsets Ready
To determine precautions to take in preparing handsets for
use in the system
CHAPTER 5
SME VoIP Administration
Interface
To learn about the Configuration Interface and define full
meaning of various parameters needed to be setup in the
system.
APPENDIX –
HOW-TO SETUP A
DUAL-CELL SYSTEM
Multi-Cell Setup & Management
Learn how to add servers and setup multiple bases into a
multi-cell network
APPENDIX –
ADDING
EXTENSIONS
Registration Management –
Handsets
Learn how to register handset and extensions to base
stations