System Guide

SME VOIP SYSTEM GUIDE 4.7 59 | P a g e
Proprietary and Confidential
5.12.2 DECT System Settings
Description of DECT Settings for Specific Base units is as follows:
Screenshot
PARAMETER
DEFAULT
VALUES
DESCRIPTION
DECT SYSTEM
RFPI
Not able
This is a radio network identity accessed by all Base units in a specific multi-
cell system. It composed of 5 octets. It is actually 5 different variables
combined together.
RFPI Format: XX XX XX XX XX (where XX are HEX values)
ALLOW MULTI
PRIMARY:
Disabled
This feature is used for multi-location setups. Allows two or more primary in
the same system.
The two cells will be unsynchronized, and handover will not be possible.
“Auto Configure DECT sync source tree” must be enabled for this feature to
also be enabled
AUTO CREATE
MULTI
PRIMARY:
Disabled
By enabled the system can generate cells in case a base goes into faulty
mode. Two cells will only be generated in case no radio connection between
the two cells is present. In order to recover the full system after establishing
of the faulty base, the system must be rebooted.
Allow multi primary must be enabled for this feature to also be enabled.
AUTO
CONFIGURE
DECT SYNC
SOURCE TREE
Enabled
Enable this to allow the system to automatically synchronize the multi-cell
chain/tree.
NOTE: Must be enabled in order to allow a new primary to recover in case the
original primary goes into faulty mode.
NOTE: To run with a system with two separate primaries in two locations “Allow multi primary” and “Auto configure
DECT sync source tree” must be enabled. To add the second primary the slave must manually be configured as
primary. Alternatively, the “Auto create multi primary” must be enabled.