System Guide

SME VOIP SYSTEM GUIDE 4.7 18 | P a g e
Proprietary and Confidential
• 1 x charger
• 1 x Handset Unit, 1 x Battery cover
Damage Inspection:
The following are the recommended procedure for you to use for inspection:
1. Examine all relevant components for damage.
2. Make a “defective on arrival – DOA” report or RMA to the operator. Do not move the shipping carton until
the operator has examined it. The operator/regional representative will initiate the necessary procedure to
process this RMA. They will guide the network administrator on how to return the damaged package if
necessary.
3. If no damage is found, then unwrap all the components and dispose of empty package/carton(s) in
accordance with country specific environmental regulations.
4.2 Before Using the Phone
Here are the pre-cautions users should read before using the Handset:
Installing the Battery
1. Never dispose battery in fires, otherwise it will explode.
2. Never replace the batteries in potentially explosive environments, e.g. close to inflammable liquids/ gases.
3. ONLY use approved batteries and chargers from the vendor or operator.
4. Do not disassemble, customize, or short circuit the battery
Using the Charger
Each handset is charged using a handset charger. The charger is a compact desktop unit designed to charge and
automatically maintain the correct battery charge levels and voltage.
The charger Handset is powered by AC supply from 110-240VAC that supplies 5.5VDC at 600mA.
When charging the battery for the first time, it is necessary to leave the handset in the charger for at least 10 hours
before the battery is fully charged and the handset ready for use.
Handset in the Charger
For correct charging, ensure that the room temperature is between 5°C and 25°C/41°F and 77°F. Do not place the
handset in direct sunlight. The battery has a built-in heat sensor which will stop charging if the battery temperature is
too high.
If the handset is turned off when placed in charger, only the LED indicates the charging. When handset is turned off,
the LED flashes at a low frequency while charging and lights constantly when the charging is finished. There will be
response for incoming calls.
If the handset is turned on when charging, the display shows the charging status.
Open Back Cover
1. Press down the back cover and slide it towards the bottom of the handset.