System Guide

SME VOIP SYSTEM GUIDE 4.7 110 | P a g e
Proprietary and Confidential
DO NOT DISTURB
Yes
CALL FORWARD
UNCONDITIONAL
Yes
CALL FORWARD NO
ANSWER
Yes
CALL FORWARD BUSY
Yes
EMERGENCY CALL
Yes
FCC Warning
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15
of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference
to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to
try to correct the interference by one or more of the following measures:
—Reorient or relocate the receiving antenna.
—Increase the separation between the equipment and receiver.
—Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
—Consult the dealer or an experienced radio/TV technician for help.
Changes or modifications to this equipment not expressly approved by the party responsible for compliance could void
the user’s authority to operate the equipment.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This
device may not cause harmful interference, and (2) this device must accept any interference received, including
interference that may cause undesired operation.
For Handset
SAR tests are conducted using standard operating positions accepted by the FCC with device transmitting at its highest
certifed power level in all tested frequency bands, although the SAR is determined at the highest certified power level,
the actual SAR level of the device while operating can be well below the maximum value. Before a new model device
is an available for sale to the public, it must be tested and certifed to the FCC that it does not exceed the exposure limit
established by the FCC, tests for each device are performed in positions and locations as required by the FCC. For body
worn operation, this model device has been tested and meets the FCC RF exposure guidelines when used with an
accessory designated for this product or when used with an accessory that contains no metal.
For Base
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment
should be installed and operated with minimum distance 20cm between the radiator& your body. This transmitter must
not be co-located or operating in conjunction with any other antenna or transmitter located or operating in conjunction
with any other antenna or transmitter.