User's Manual

SME VoIP System Guide, Version 2.6

Proprietary and Confidential

Chapter:

Multi

-cell Setup & Management

STEP 12 Navigate back to the Multi cell settings page by clicking Multi-cell url link at the left column.

The revised Multi cell settings page shows the relevant base stations synchronized together.

By default, the system uses the first registered base station as the master base unit.

STEP 13 On the Multi-cell settings page, scroll to the DECT system settings and Enable or Disable the

“Auto configure DECT sync option source tree” (See description in the table below). The

DECT system RFPI parameter is computed by the system (It’s often greyed in a multi-cell

system configuration).

STEP 14 Next, on the MAC-units in chains section, you can manually configure the synchronisation

source tree of the multi-cell system. Multi-cell settings page, scroll to the DECT system settings and

Enable or Disable the “Auto configure DECT sync option source tree” (See description in the table

below). The DECT system RFPI parameter is computed by the system (Its often greyed in a multi-cell

system)