User's Manual

SME VoIP System Guide, Version 2.6
Proprietary and Confidential
Chapter:
SME VoIP Administration Interface
57
5.12 Multi-cell Parameter Definitions
In this section, we describe the different parameters available in the Multi-cell configurations menu.
5.12.1 Settings for Base Unit
Description of Settings for Specific Base units is as follows:
Screenshot
Multicell status covers status of data synchronization. The status “Keep-alive” means normal operation.
Parameter
Default values
Description
Multi cell
system
Disabled
Enable this option to allow the Base unit to be set in multi-cell mode
(can be set either as master or slave in the multi-cell chain system –
refer to MAC-units in Chain section for details).
Valid Inputs: Enable, Disable
Must “save and reboot” after change from disabled to enable.
System chain ID
Empty
This is an identifier (in string format e.g. 2275) that is unique for a
specific multi-cell system.
The Chain ID value MUST not be equal to a used SIP account. The Chain
ID use up a SIP account with this value.
Note: Chain ID is used as SIP account for check Sync. Default value is
512, which means extension 512 must not be used – unless the chain
ID is modified. Chain ID can be modified by provisioning only.
Note: There can be several multi-cell systems in SME network. Up to 24
levels of base stations chains are permitted in a setup.
Valid Input: The Web site allow max 5 digits in this field.
Synchronization
time (s)
60 sec
This specifies the period in seconds when elements/nodes (e.g. Base
units) in a specific Multi-cell will synchronise to each other.