Extra Extension Unit Installation Guide
The lightning flash with arrowhead symbol within an equilateral triangle is intended to alert the user to the presence of uninsulated “dangerous voltage” within the product’s enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons. “Caution” Main plug is used as disconnect device and it should remain readily operable during intended use.
IMPORTANT SAFETY INSTRUCTIONS When using your telephone equipment, basic safety precautions should always be followed to reduce the risk of fire, electric shock and injury to persons, including the following: 1. Do not use this product near water, for example, near a bath tub, wash bowl, kitchen sink or laundry tub, in a wet basement or near a swimming pool. 2. Avoid using a telephone (other than a cordless type) during an electrical storm. There may be a remote risk of electric shock from lightning. 3.
FCC and IC information This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Privacy of communications may not be ensured when using this extension unit. Caution: To maintain the compliance with the FCC’s RF exposure guideline, place the extension unit at least 20 cm from nearby persons.
DEAR CUSTOMER We would like to thank you for purchasing our Wireless Phone Jack and/or an additional Wireless Phone Jacks. We hope you will enjoy it. Please read the following thoroughly and observe the operating instructions and information provided. Copyright ©. All rights reserved. All forms of copying or reproduction of the product or its associated user guide are strictly prohibited. This product is manufactured for RTX Products A/S.
Note: Please read and follow carefully the instruction described below.
INSTALLATION Registration 1) Make sure the power to the base unit is switched on. 2) The registration described in this section is based on RTX fixed device, TLE base. This may not be applied to Thomson’s fixed device unless the registration procedure is specified by Thomson and agreed by RTX. 3) Whenever an Extension Unit is not registered it will transmit a special pattern by pulsating the line voltage.
Deregistration 1) The registration in an extension unit is deleted by power cycling the unit 5 times after each other. The power must not be on for more than 4 seconds at time during this. 2) In practice the procedure is as follows: When an extension unit is registered, its LED will initially slow flash between green and red. This means that the first color after power up is not red.
TROUBLESHOOTING Extension unit LED off green slow flash green slow flash between green and red red fast flash red for 5 seconds Description No power Solution Check that the Extension units properly connected to a power outlet and that power is on. Unit locked to base Normal operation, the Unit locked to base. Unit in call Normal operation, the unit in call Unit registered, but not Check that both units (PABX and Extension) are properly con-nected to power locked to base. LED is outlet and switched on.
Extension unit LED slow flash between green and yellow fast flash between red and green Continuously 5 fast flashes red and 2 seconds off Description Unit is on limit of range. This has precedence over the normal locked to base indication. It will not be used in call. Service mode. Unit has been set into service mode. If registration mode, it will flash like this until registration completes The extension unit has been subscribed to and old unsupported base unit version. Ext must be restarted to continue.
