User's Manual

SME VoIP System Guide, Version 1.5
Proprietary and Confidential
Chapter: Firmware Upgrade Management
68
10.9 Reboot the Base station(s)
STEP 17 In principle the base station(s) should reboot automatically when the Start update button is
selected > to begin the firmware update procedure.
If for some unknown reasons the base station does restart, then the admin must manually reboot
the base station so the firmware update process can begin in the base station.
Make sure the URL is shown on the page before rebooting the base station, e.g.
tftp://192.68.50.1/FwuPath
Click OK button from the dialog window. A successful restart of the base stations will lead to a display of
the page: Gateway has been reset. The firmware update is now in progress.
STEP 18 Wait about 3-5 minutes, Reboot the base/gateway.
The base/gateway will now be updated (base LED will flash). The software version number on the
start page should be changed to the new version number.
The message “Base FWU ended with exit code -2101” is shown in the debug log and the new
firmware will be running after a restart of the base/gateway.