User's Manual

SME VoIP System Guide, Version 1.5
Proprietary and Confidential
Chapter: Firmware Upgrade Management
61
10.3 Create Firmware Directories
Within the same TFTP Server Interface do the following:
STEP 1 Make a folder named “BeatUs” in the TFTP-Root and place the fwu file(s)/(Firmware) in this
folder. The base firmware must be renamed to “BeatUsSw_v00xx.fwu”.
STEP 2 The admin from the service provider’s side must create the relevant firmware directory in
the server where both old and new firmware(s) can be placed in it. (See the STEP above)
The firmware directory or path should be \<Server>\<FwuPath>\BeatUs\, where <Server> is the
root directory of the server (e.g. C:\TFTP-Root) and <FwuPath> is a folder within the <Server> that
contains the BeatUs directory.
IMPORTANT:
The BeatUs directory name cannot be changed.
10.4 Login to Base SME Configuration Interface
STEP 3 Connect the Base station to a private network via standard Ethernet cable (CAT-5).
STEP 4 Open any standard browser and enter the address:
http://ipdect<MAC-Address-Base-Station>
e.g. http://ipdect00087B00AA10. This will retrieve the HTTP Web Server page from the base
station with hardware address 00087B00AA10.
STEP 5 You can also use an IP/network protocol analyser e.g. Wireshark (freeware program) to
identify which IP the base has received.