User's Manual

DECT Messenger – Reference Guide
Important safety information
Charge the M155 handset only in combination with
the M155 DECT Handset Desktop charger and the
KTEC KSLFB0500035W1UV-1 adapter that comes
with the product. Plug the corresponding AC plug
from the package and plug the KTEC
KSLFB0500035W1UV-1 adapter in a wall outlet
socket near the equipment for easy access/removal
of the AC/DC adaptor. Never attempt to open your
M155 handset or adapter, disassemble it; there are
no user-serviceable parts inside. The embedded
battery of the M155 needs no replacement during the
normal life time of the handset.
Important battery information
This product uses rechargeable Lithium-Polymer
batteries 3.7V, 400mAh, which is produced by
SHENZHEN BAK TECHNOLOGY CO., LTD. with
model number BAK402838P. Do not use any other
type, since this may present a risk of leakage, fire,
explosion or other hazardous situation. Never
disassemble, customize or short-circuit batteries. Do
not place battery in fire or heat the battery. Charge
the handset only in combination with M155 DECT
Handset Desktop charger and the KTEC
KSLFB0500035W1UV-1 adapter that comes with the
product.
Sensitive Electronic Environment
Any radio-based equipment can potentially cause
interference with other equipment and can be
interfered from other equipment. This also applies for
DECT equipment. However due to the very low
transmission power level the chances for interference
are very small. Research proves that operational
DECT phones normally don’t influence electronic
equipment however some precautions must be taken
into account for sensitive electronic equipment e.g.
sensitive laboratory equipment. When DECT phones
operate in straight nearness of sensitive electronic
equipment incidental influence can appear. You are
advised not to place the DECT phone on or close
(less than 10cm) to this kind of equipment, even in
standby mode. Please also use the other
documentation supplied with the various parts of your
telephone system.
Product disposal information
For countries in the European Union
The symbol depicted here has been
affixed to your product in order to
inform you that electrical and electronic
products should not be disposed of as
municipal waste.
Electrical and electronic products including the
cables, plugs and accessories should be disposed of
separately in order to allow proper treatment,
recovery and recycling. These products should be
taken to a designated facility where the best available
treatment, recovery and recycling techniques are
available. Separate disposal has significant
advantages: valuable materials can be re-used and it
prevents the dispersion of unwanted substances into
the municipal waste stream. This contributes to the
protection of human health and the environment.
Please be informed that a fine may be imposed for
illegal disposal of electrical and electronic products
via the general municipal waste stream. In order to
facilitate separate disposal and environmentally
sound recycling, arrangements have been made for
local collection and recycling. In case your electrical
and electronic products need to be disposed of
please refer to your supplier or the contractual
agreements that your company has made upon
acquisition of these products.
At www.nec-philips.com/weee you can find
information about separate disposal and
environmentally sound recycling.
For countries outside the European Union
Disposal of electrical and electronic products in
countries outside the European Union should be
done in line with the local regulations. If no
arrangement has been made with NEC or your
supplier, please contact the local authorities for
further information.