User's Manual

repeater to another location.
Installing the repeater
Be sure the wall material can hold the weight of the repeater. Never
install a repeater in damaged or decaying wall material.
Step 1: Hold the repeater in its final location, and mark the center of the top
edge.
Step 2: From the edge mark, measure down approximately 1 1/2 inches, and
mark the screw location.
Step 3: At the screw location, use a 3/16ths drill bit to make a pilot hole
approximately 1 inch deep.
Step 4: Place the wall anchor into the pilot hole and tap it gently with a
hammer until the anchor is flush with the wall.
Step 5: Insert the mounting screw into the anchor, leaving approximately 1/4
inch space between the screw head and the wall.
Step 6: Put the repeater over the screw head and slide it down into place.
Step 7: Connect the repeater to the 120 V AC power outlet.
Multiple-repeater systems
You can register up to 6 repeaters to one base as long as the repeaters are a
minimum of 30 feet apart. Don't forget that the signal can cross through walls and
floors.