User's Manual

Registration for a daisy-chain layout
Registering the repeaters to operate in a daisy-chain or sequential layout
requires network administrator access and configuration software. Contact your
installer or refer to the UDR100 Administrator's Guide (provided with the
configuration software) for more information.
Registering to a different base
Once the repeater is registered, you need to reset it before you can change the
registration to a different base. If you want to reset the repeater and clear its
registration, follow the steps below:
Step 1: Disconnect the power.
Step 2: Reconnect the power for 1 to 5 seconds, and disconnect it again.
Step 3: Reconnect the power for 25 to 35 seconds.
Step 4: Disconnect the power, and perform the registration procedure with the
new base.
3) Installing the repeater
Finding the right location
To get the best operating conditions for the repeater, it is important to place it
correctly. Here are a few tips for placing repeaters.
•
Place the repeater as high as possible, but
at least 6 feet
off the ground
•
Make sure you have good reception from the base
•
Make sure the location is close to a standard 120 V AC power outlet. Never
install electrical cords across a traffic area: they can create a trip hazard or
become damaged and create a fire or electrical hazard.
•
Allow
at least 30 feet
between repeaters (if you are installing repeaters
across multiple floors, don't forget to allow 30 feet
vertically
, also)
•
Avoid sources of electrical interference, such as hi-fi systems, office
equipment or microwave ovens.
•
Avoid heat sources and direct sunlight
•
Avoid things that can interfere with radio signals, such as metal doors, thick