User's Manual

Use ONLY the power adapter that came with your repeater. A
different power adapter may cause an electrical hazard or damage
the repeater.
Setting up the base
Changing the telephone system PIN
Before you start the registration process, you must reset the system PIN of your
telephone to
0000
(consult the manual that came with your base for more
information). After you reset the PIN, make sure to re-register the handset you
used back to the base station.
Automatic registration
The repeater seeks out the base with strongest DECT/GAP signal and
automatically registers to that base.
Step 1: Make sure the repeater is powered off (i.e., the AC power adapter is
not connected).
Step 2: Set the base into registration mode. (Consult the owner's manual that
came with your base station for more information.
Step 3: Use the AC adapter to connect the repeater to a standard 120 V AC
outlet. (Do not use a power outlet controlled by a wall switch.) The
LED on the repeater flashes briefly, then remains on and steady.
If the LED continues to flash, try registering the repeater again.
The repeater is now registered to this base and is ready to use.
You can safely disconnect the power and move the repeater to the selected
location; the repeater will stay registered to the base.
The repeater remains registered even if you disconnect the AC
adapter or there is a power failure. If you want to clear the
registration (for example, so you can register to a different base),
you must reset the repeater.