User's Manual

Version 1.2 Page | 64
Profile Alias
An alias or user-friendly name to help identify the different profiles when
selecting which profiles to enable for the individual handsets.
Alarm Type
The type of alarm is dependent of what kind of event that has triggered the alarm
on the handset. The handset supports either of the following categories:
Man Down
No Movement
Running
Pull Cord
Emergency Button
Disabled
Alarm Signal
The way the alarm is signaled as it is received on the handset.
Message: The alarm is sent as a text message to an alarm server, and is
accordingly received as an alarm message on the handset(s) receiving the alarm.
Call: The alarm is made as an outgoing call to the specified emergency number
for the extension.
Alarm Priority
The priority of the alarm. A higher priority alarm can interrupt a lower priority
alarm (higher number = higher priority).
0-7: The Alarm Priority can be set from 0-7.
Stop Alarm from
Handset
Enable/disable the possibility to stop/cancel the alarm from the handset.
Trigger Delay
The period from when the alarm has fired until the handset shows a pre-alarm
warning. If set to 0, there will be no pre-alarm warning, and the alarm will be
signalled immediately.
Stop Pre-Alarm
from Handset
Enable/disable the possibility to stop/cancel the pre-alarm from the handset.
Pre-Alarm Delay
The period from the pre-alarm warning is shown until the actual alarm is
signalled.
Howling
Enable/disable if howling shall be started in the handset, when the alarm is
signalled. If disabled, only the configured signal is sent (call or message).
6.9.2.1 Alarms Sent as Messages
When the “Alarm Signal” is set to “Messages”, an alarm messaging server needs to be setup on the
base station. This is done by entering the menu “Management”, enabling “Text Messaging Enabled”