User's Manual

SME VoIP System Guide, Version 1.5
Proprietary and Confidential
Chapter: Multi-cell Setup & Management
96
13.9.2 Case ##2: Location with co-located partners
To illustrate this setup, two slave base stations are synchronised to one master base in the two office
blocks.
It is not necessary to deploy a dedicated Base unit at the car park area because it is likely no telephony
traffic or call will be placed at the area. Here is diagram to illustrate Case ##2.
The procedure:
STEP 1 Follow the steps described in sections 13.4 to 13.8
STEP 2 On the Network page of each base define the DECT sync source settings as illustrated in the
table below.
STEP 3 Save and reboot each base to complete case ##2 setup
Multi Cell Page of Base Stations
Recommended settings of MAC-units in Chain section of page (Other different settings exist):
RPN
Ver
MAC Addr
IP Addr
IP Status
DECT sync
source
DECT
Property
00
XX
XX:XX:XX…
XXX.XXX…
Connected
1: RPN:04
04
XX
XX:XX:XX…
XXX.XXX…
Connected
1: RPN:04
Master
08
XX
XX:XX:XX…
XXX.XXX…
Connected
1: RPN:04