User's Manual

SME VoIP System Guide, Version 1.5
Proprietary and Confidential
Chapter: Multi-cell Setup & Management
91
STEP 14 On the Multi-cell settings page, scroll to the DECT system settings and Enable or Disable the
“Auto configure DECT sync option source tree” (See description in the table below). The
DECT system RFPI parameter is computed by the system (Its often greyed in a multi-cell
system configuration).
STEP 15 Scroll to the SIP system settings section, configure and save the parameter based on the
description below:
Parameter
Description
## of SIP
accounts before
distributed load
The maximum number of handsets or SIP end nodes that are permitted to
perform location registration on a specific Base unit before load is distributed to
other base units.
Note: A maximum of 8 simultaneous calls can be routed through each Base units
in a multi-cell setup.
Permitted Input: Positive Integers (e.g. 6)
SIP Support for
multiple
registrations per
Enable this option so it is possible to use same extension (i.e. SIP Account) on
multiple phones (SIP end nodes). These phones will ring simultaneously for all
incoming calls. When a phone (from a SIP account group) initiates a handover