User's Manual

SME VoIP System Guide, Version 1.5
Proprietary and Confidential
Chapter: SME VoIP Administration Interface
55
Location Area Length (Lal):
A unique code sent to the terminal during location registration to determine the
size of the location or cell area.
Type: 8-bit value (from 0x00 to 0xFF). E.g Lal=0x04
RFPI: 11 6E 60 49 04
Auto configure
DECT sync source
tree
Enable this to allow the network to automatically synchronise the multi-cell
chain/tree. (Not available in some base station firmware(s)).
Permitted Inputs: Enable, Disable
9.8.3 SIP System Settings
Description of SIP Settings for Specific Base units is as follows:
Parameter
Description
## of SIP
accounts before
distributed load
The maximum number of handsets or SIP end nodes that are permitted to
perform location registration on a specific Base unit before load is distributed to
other base units.
Note: A maximum of 8 simultaneous calls can be routed through each Base units
in a multi-cell setup.
Permitted Input: Positive Integers (e.g. 6)
SIP Support for
multiple
registrations per
account
Enable this option so it is possible to use same extension (i.e. SIP Account) on
multiple phones (SIP end nodes). These phones will ring simultaneously for all
incoming calls. When a phone (from a SIP account group) initiates a handover
from Base X to Base Y, this phone will de-register from Base X, and register to
Base Y after a call.
Note: Choose Yes when the SIP server supports this feature otherwise choose No
for the Sip server does not support this feature.
Permitted Input: Yes, No
9.8.4 MAC-units in Chain
The definitions for various parameters settings of various chain levels for a typical multi-cell system.
Parameters
Description
ID
Base unit identity in the chained network.
Permitted Output: Positive Integers
RPN
The Radio Fixed Part Number, is an 8-bit DECT cell identity allocated by the