User's Manual

SME VoIP System Guide, Version 1.5

Proprietary and Confidential

Chapter: Making Handset Ready

initiate the necessary procedure to process this RMA. They will guide the network administrator on

how to return the damaged package if necessary.

3. If no damage is found then unwrap all the components and dispose of empty package/carton(s) in

accordance with country specific environmental regulations.

7.2 Before Using the Phone

Here are the pre-cautions users should read before using the Handset:

Installing the Battery

1. Never dispose battery in fires, otherwise it will explode.

2. Never replace the batteries in potentially explosive environments, e.g. close to inflammable liquids/

gases.

3. ONLY use approved batteries and chargers from the vendor or operator.

4. Do not disassemble, customise or short circuit the battery

Using the Charger

Each handset is charged through the use of a handset charger. The charger is a compact desktop unit

designed to charge and automatically maintain the correct battery charge levels and voltage.

The charger Handset is powered by AC supply from 110-240VAC that supplies 5.5VDC at 600mA.

When charging the battery for the first time, it is necessary to leave the handset in the charger for at least

10 hours before the battery is fully charged and the handset ready for use.

Handset In the Charger

For correct charging, ensure that the room temperature is between 0°C and 25°C/32°F and 77°F. Do not

place the handset in direct sunlight. The battery has a built-in heat sensor which will stop charging if the

battery temperature is too high.

If the handset is turned off when placed in charger, only the LED indicates the charging. When handset is

turned off, the LED flashes at a low frequency while charging and lights constantly when the charging is

finished. There will be response for incoming calls.

If the handset is turned on when charging, the display shows the charging status.

Open Back Cover

1. Press down the back cover and slide it towards the bottom of the handset.

2. Remove Back Cover from Handset

Handset Serial Number

The serial number (IPEI/IPUI number) of each handset is found either on a label, which is placed behind the

battery, or on the packaging label. First, lift off handset back cover and lift the battery and read the serial

number.