User Guide

BT Tag GUIDE 4.8
Proprietary and Confidential
1. About This Document
This document describes the functionality of the RTX8210/RTX8212 BT Tag in RTX generic mode. For customer specific
modes refer to specific customer agreements, which describe the software operational deviations from this
document.
1.1 Audience
Who should read this guide? First, this guide is intended for networking professionals responsible for designing and
implementing RTX based enterprise networks.
Second, network administrators and IT support personnel that need to install, configure, maintain, and monitor
elements in a “live” SME VoIP network will find this document helpful. Furthermore, anyone who wishes to gain
knowledge on fundamental features in the sending beacons system, can also benefit from this material.
1.2 Important Assumptions
This document was written with the following assumptions in mind:
• You understand network deployment in general
• You have working knowledge of basic TCP/IP/SIP protocols, Network Address Translation, etc...
• A proper site survey has been performed, and the administrator has access to these plans
1.3 Warning Statements
The following warning statements are to be considered
1.4.1 FCC
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference that may cause undesired operation.
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This
transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.
Any Changes or modifications not expressly approved by the party responsible for compliance could void the user’s
authority to operate the equipment.
1.4.2 IC
This device contains license-exempt transmitter(s)/receiver(s) that comply with Innovation, Science and Economic
Development Canada’s license-exempt RSS(s). Operation is subject to the following two conditions:
(1) This device may not cause interference.
(2) This device must accept any interference, including interference that may cause undesired operation of the device.
Cet appareil contient des émetteurs / récepteurs exemptés de licence conformes aux RSS (RSS) d'Innovation, Sciences
et Développement économique Canada. Le fonctionnement est soumis aux deux conditions suivantes:
(1) Cet appareil ne doit pas causer d'interférences.
(2) Cet appareil doit accepter toutes les interférences, y compris celles susceptibles de provoquer un fonctionnement
indésirable de l'appareil.
This equipment complies with ISEDC radiation exposure limits set forth for an uncontrolled environment