Datasheet
Table Of Contents
11© 03/2018 | Technical changes without notice. | RTW GmbH & Co.KG | Am Wassermann 25 | 50829 Köln | Fon +49 221. 70 913-0 | Fax +49 221. 70 913-32 | rtw@rtw.com | www.rtw.com
Specifi cations
System
General
Power requirements: +24 V DC (external 2 A max. overcurrent
protective device shall be installed!)
Current drain: 160 mA nominal, power-up current is much higher
Display: Capacitive 4.3’’ touch screen (272 x 480 pixel)
Connectors: 1 x 4-pin locking low voltage connector
type Binder 710 (DC)
1 x USB Mini-B; USB 2.0 Full Speed con-
nectors for data exchange between Devicer
DC1 computer software and TM3S
1 x GPIO (RJ-12-6P6C) for defi ned functions
or preset recall
2 x RCA-F (unbalanced, analog inputs)
2 x RCA-F (unbalanced, S/PDIF in-/output)
1 x 25-pin Sub-D-F (balanced, alternative
analog, up to 3 x AES3 in-/outputs)
Dimensions (W x H x D): Display unit: 82.5 x 138 x 50 mm
Interface box: 146 x 29 x 85 mm
Weight: Display unit approx. 320 g, interface box approx.
460 g, w/o mains adapter
Operating temperature: +5° to +40° C
Functions
• Instruments can be scaled and freely positioned
• PPM up to 6 channels
• Loudness-Meter: ITU-R BS.1770-3/1771-1,
EBU R128, ATSC A/85, ARIB, OP-59,
AGCOM, CALM, custom mode
• Loudness Test Time Control
• Loudness Range instrument (LRA)
• Loudness Chart instrument, SPL meter
• Stereo Correlator
• Dialnorm (w/o speech intelligence)
• AES3 status monitor
• Numerical displays
• Moving Coil instruments, Timecode Reader
Analog Inputs
2 analog inputs, 2 x RCA or alternativ via 25-pin
Sub-D-F connector
• RCA
- Input sensitivity
for 0 dB reading
RCA: via potentiometer adjustable from 150 mV to 30 V
- Impedance: > 10 kOhm
• Sub-D
- Input sensitivity
for 0 dB reading
Sub-D: +6 dBu (1,55 V)
- Reference level: via software adjustable from 0 to +10 dBu
- Max. input level: +24 dBu
- Impedance: > 10 kOhm, electronically balanced
Digital Inputs/Outputs
1 digital S/PDIF input, RCA, unbalanced, 75
1 digital S/PDIF ouput, RCA
3 AES3 inputs, transformer balanced, 110 ,
Sub-D-F connector, 25-pin (in-/output)
3 AES3 outputs, transformer balanced, Sub-D-F
connector, 25-pin (in-/output)
Sampling rates: 44.1, 48, 96 kHz, synchronisation to digital input
signal