Specifications

76 - RedBoot Procedures DeviceMaster Installation and Configuration Guide: 2000506 Rev. B

Establishing a Telnet Connection

7. Go to the appropriate task:

• Determining the Network Settings

on Page 77

• Configuring the Network Settings on Page 77

• Determining the Bootloader Version on Page 78

• Resetting the DeviceMaster on Page 78

• Uploading Firmware on Page 79

• Configuring Passwords on Page 82

• Redboot Command Overview on Page 83.

Establishing a Telnet

Connection

Use the following procedure to telnet to the DeviceMaster.

1. Open a telnet session, enter the DeviceMaster IP address. If using Windows, open a

Command window and type telnet [ip_address].

Note: Press the Enter key if you have not programmed a password or use the

password previously configured. The DeviceMaster does not come pre-

programmed with a password.

2. Type reset, and close the session.

3. Open a new telnet session, enter the DeviceMaster IP address, and the password.

4. Type dis to disable the Bootloader.

5. Verify that the system responds with a Loading disabled message.

6. Go to the appropriate task:

• Determining the Network Settings

on Page 77

• Configuring the Network Settings on Page 77

• Determining the Bootloader Version on Page 78

• Resetting the DeviceMaster on Page 78

• Uploading Firmware on Page 79

• Configuring Passwords on Page 82

• Redboot Command Overview on Page 83.

*********************************************

** Comtrol DeviceMaster Bootloader Version 3.05

** RedBoot(tm) environment - built 08:13:02, Apr 4 2008

** Platform: Comtrol DeviceMaster (ARM 7TDMI)

*********************************************

FLASH: 64 blocks of 65536 bytes each

FLASH: 4194304 bytes (0x05000000 - 0x05400000)

RAM: 8126464 bytes (0x00000000 - 0x007c0000)

RedBoot> dis

Loading disabled

RedBoot> _