Specifications

DeviceMaster Installation and Configuration Guide: 2000506 Rev. B Hardware Installation - 29
16-Port (DeviceMaster PRO)
6. Verify that the PWR LED has completed the boot cycle and network connection for
the DeviceMaster is functioning properly using the table below.
7. Go to Initial Configuration
on Page 33 for default network settings and how to
configure the DeviceMaster for use.
DeviceMaster PRO 16-Port LED Description
Red
LED
(Front
panel)
Red LED on the front panel of the DeviceMaster PRO is lit, indicating you
have power and it has completed the boot cycle.
Note: The LED flashes while booting and it takes approximately 15
seconds for the Bootloader to complete the cycle. When the
Bootloader completes the cycle, the LED has a solid, steady light
that blinks approximately every 10 seconds.
LNK/
ACT
The red LNK/ACT LED is lit, indicating
that you have a working Ethernet
connection.
COL
If the red COL LED is lit, there is a
network collision.
100
If the red 100 LED is lit, it indicates a
working 100 MB Ethernet connection (100
MB network, only). If the LED is not lit, it
indicates a 10 MB Ethernet connection.
Note: For additional LED information, go to the PWR/Status LED table on Page 97.
LNK/
ACT
COL
100
10/100 NETWORK
UP DOWN