Specifications

DeviceMaster Installation and Configuration Guide: 2000506 Rev. B Hardware Installation - 27
16-Port (DeviceMaster RTS - External Power Supply)
5. Verify that the PWR LED has completed the boot cycle and network connection for
the DeviceMaster RTS is functioning properly using the table below.
6. Go to Initial Configuration
on Page 33 for default network settings and how to
configure the DeviceMaster for use.
DeviceMaster RTS 16-Port (External Power Supply) LED Descriptions
Red
LED
Red LED on the front panel of the DeviceMaster is lit, indicating you have
power and it has completed the boot cycle.
Note: The LED flashes while booting and it takes approximately 15 seconds for
the Bootloader to complete the cycle. When the Bootloader completes
the cycle, the LED has a solid, steady light that blinks approximately
every 10 seconds.
LNK
ACT
The red LNK ACT LED is lit, indicating that you
have a working Ethernet connection.
COL
If the red COL LED is lit, there is a network
collision.
100
If the red 100 LED is lit, it indicates a working 100
MB Ethernet connection (100 MB network, only).
If the LED is not lit, it indicates a 10 MB Ethernet
connection.
Note: For additional LED information, go to the PWR/Status LED table on Page 97.
LNK
ACT
COL
100
10/100 NETWORK
UP DOWN