Specifications

DeviceMaster Installation and Configuration Guide: 2000506 Rev. B Hardware Installation - 17
Mounting the Embedded
Mounting the
E m b e dde d
Use the following procedure to mount the DeviceMaster 1-Port Embedded with the 5-
30VDC power supply.
Observe proper ESD techniques when handling the DeviceMaster.
1. Carefully remove the DeviceMaster from the anti-static bag, following standard
electrostatic device handling procedures.
Note: Write down the MAC address located on a label on the bottom (solder side)
center of the DeviceMaster because you may need it during configuration.
2. Mount the DeviceMaster for your environment using 1/4” stand-offs to separate the
DeviceMaster from the base.
3. Use one of the following methods to ground the DeviceMaster.
Through the power supply by connecting the ground wire on the power cable
using plastic or metal stand-offs.
Through the chassis, using metal stand-offs. If plastic stand-offs are used to
mount the board, then you must ground the DeviceMaster using the power cable.
Note: The maximum diameter of the metal stand-offs should be 0.175” with a 4-40
machine screw. Metal stand-offs are not provided with the DeviceMaster.
4. Optionally, attach the light pipes. The following light pipes have been tested and found
to function; Bivar, Inc. (P/N:LP-230) and Ledtronics, Inc.
(P/N:LTP003-0CW-001).
Caution
Non-plated/non-grounded mounting holes 0.116” diameter (+/-0.003”).
WARNING: Holes in hatched area are not mounting holes.
Maximum component height above board is 0.55”.
Ethernet connection J2: J2 overhangs board edge by 0.14” and the height is 0.55”.
LED light pipe mounting holes. The LED light pipes are not provided.
Serial port connector J3: 0.1” pin spacing, 0.025” square pin diameter, and 0.230”
pin height.
Debug port connector J4: 0.1” pin spacing, 0.025” square pin diameter, and 0.230”
Power connector; the mating connector is Weidmuller P/N: 152651.
1
3
4
5
6
7
8
9
Plated/chassis grounded mounting hole 0.116” diameter (+/-0.003”).
2
pin height.
5-30VDC Model
Caution