Technical data

REVISIONS
I
ZONE REV. DATE DESCRIPlmN
PROVED
i I
SEE SHEl7 I I i I
.CUT $
WIRE
SLEEVE
ENDS
FRoUT PANEL
To
MOUhlTidG NUT
X LR-4 -3 1
GooSENECK
MIL
V
LIGHT BOARD
MOMENTARY
M!L
8.
For Unmritched label information mic) see on drawing RMSWBCS FDXXMC (Dual Usten. Program input, end
A
On RMS300 unlts a&: transformer T5 is not Installed. Add two 24 ewg red
i jumpers in place ofT5 on bottom side of the board as shown.
/3\
On SPK300 UnftSm install jumper across S1. Install trensformerT5 (RTS
#23060006W), and remove resistor R15.
Gooseneck mic not Installed on SPKW units. Cut and sleeve wire ends.
For options withoute light board (CC26)
cut and sleeve wire ends.
NOTES: