Intercom System User Manual
Table Of Contents
- READ ME FIRST
- CHAPTER 1 Menu List for DKP-8, DKP-12, and KP-12 Keypanels
- CHAPTER 2 Power-Up and Initial Settings
- CHAPTER 3 Basic Intercom Operation
- CHAPTER 4 Telephone Operation
- CHAPTER 5 Using the Top-Level Menu
- General Description
- Top Level Menu, - - - - (Clear call waiting)
- Top Menu Level, Call List Names
- Top Level Menu, Display
- General Description
- Top Level Menu, Display, CHANS ON
- Top Level Menu, Display, Exclusive
- Top Level Menu, Display, Group (1-4)
- Top Level Menu, Display, KEY ICOM
- Top Level Menu, Display, KEY TYPE
- Top Level Menu, Display, Level 2
- Top Level Menu, Display, Listen
- Top Level Menu, Display, Page Use
- Top Level Menu, Display, Port Num
- Top Level Menu, Display, SOLO
- Top Level Menu, Display, Version
- Top Level Menu, Key List
- Top Level Menu, Level
- Top Level Menu, Lists
- Top Level Menu, Menus
- Top Level Menu, Page (1-4)
- Top Level Menu, TGL LISN (Toggle Listen ON/OFF)
- CHAPTER 6 Menu Mode
- Select Control Operation in Menu Mode
- Menus, Autodial (for KP-12/DKP-12 Only)
- Menus, KEY ASGN
- Menus, KEY ASGN, General Description
- Menus, KEY ASGN, AUTODIAL (For KP-12, DKP-12 Only)
- Menus, KEY ASGN, AUTOFUNC
- Menus, KEY ASGN, CLEAR
- Menus, KEY ASGN, COPY
- Menus, KEY ASGN, LISTS
- Menus, KEY ASGN, LISTS
- Menus, KEY ASGN, LISTS, IFB
- Menus, KEY ASGN, LISTS, IFSL
- Menus, KEY ASGN, LOCAL I/O (For KP-12 Only)
- Menus, KEY ASGN, PHONE (For KP-12, DKP-12 Only)
- Menus, KEY ASGN, REDIAL (For KP-12, DKP-12 Only)
- Menus, KEY ASGN, UPL
- Menus, Key Opt Menu
- General Description
- Menus, KEY OPT, BTN LOCK (Button Lock)
- Menus, KEY OPT, CHIME
- Menus, KEY OPT, CLR OPT
- Menus, KEY OPT, COPY
- Remember to save you changes if you want them retained for future use. See “Menus, SERVICE, SAVE ...
- Menus, KEY OPT, EXCLUSIVE
- Menus, KEY OPT, GROUP (1-4)
- Menus, KEY OPT, LATCHING
- Menus, KEY OPT, SOLO
- Menus, SERVICE MENU
- General Description
- Menus, SERVICE, DIMMER
- Menus, SERVICE, FOOT SW (with GPI module ONLY)
- Menus, SERVICE, KEY TYPE
- Menus, SERVICE, LOCK/UNLOCK
- Menus, SERVICE, MIC CTRL
- Menus, SERVICE, MIC COMP
- Menus, SERVICE, MIC GAIN
- Menus, SERVICE, MOD ASGN
- Menus, SERVICE, MUTE LVL
- Menus, SERVICE, OPTO-ISO (KP-12 with GPI Module Only)
- Menus, SERVICE, OUT CTRL
- Menus, SERVICE, RESET
- Menus, SERVICE, SAVE CFG
- Menus, SERVICE, SET ADDR
- Menus, SERVICE, SIDETONE
- Menus, SERVICE, TALLY
- Menus, SERVICE, TEST PNL
- Menus, SERVICE, TONE
- Menus, SERVICE, USM (Unswitched Microphone, for KP-12 with Rear Connector Module Only)
- Appendix A KP-12 Audio Transmit Board Connections
- Appendix B Replacing the KP-12 Power Supply

Menu Mode
26
Menus, Autodial (for KP-12/DKP-12 Only)
NOTE: This menu is used to store autodial numbers. To assign a key that dials a specific autodial number, see page 27. To use
stored autodial numbers with an all-purpose phone key see page 14.
Store autodial numbers as follows:
1. All phone keys (including autodial or redial keys) must be OFF.
2. When you select AUTODIAL, the call waiting window will display DIAL NUM.
3. If your phone system requires you to enter a digit to request an outside line, enter that digit first. Some phone systems may
also require a brief pause after the request for an outside line. If this is the case, enter *99 after the first digit to create a
pause.
4. Finish dialing the telephone number.
5. When finished dialing, tap the SELECT control.
The call waiting window will then display TAP 0-9.
6. Tap a single key (0 through 9) to assign the telephone number to autodial number 0 through 9.
7. After an autodial number has been assigned, the call waiting window will again display DIAL NUM.
8. Repeat steps 3 through 6 to store additional autodial numbers.
9. Press and hold the SELECT control for two seconds to return to the top-level menu when you are finished entering
autodial numbers.
Table1. Keypanel Menus in Menu Mode
AUTODIAL
page 26
KEY ASGN
page 27
KEY OPT
page 35
SERVICE
page 38
AUTODIAL BTN LOCK DIMMER
AUTOFUNC CHIME FOOT SW
CLEAR CLR OPT KEY TYPE
COPY COPY LOCK
LISTS GROUP 1 MIC CTRL
ICOM
a
a. ICOM is only available for trunked intercom systems.
GROUP 2 MIC COMP
PL GROUP 3 MIC GAIN
IFB GROUP 4 MOD ASGN
IFSL LATCHING MUTE LVL
ISO SOLO
OPTO ISO
b
b. LOCAL I/O and OPTO-ISO are available only with the optional GPI module installed (KP-12 only).
P-P OUT CTRL
RLY RESET
SPCL SAVE CFG
UPL SET ADDR
PHONE SIDETONE
REDIAL TALLY
TEST PNL
TONE
USM