User guide

Q u i c k S t a r t G u i d e
2 Quick Start Guide
Initial Setup
1 Plug 12V into the RECEIVER's “PWR” port.
Max voltage is 17V. If the voltage is over ~17.5V or polarity is reversed,
The Receiver will block the dangerous voltage and not start.
2 Affix one or more MOTORS to the rods/ lens.
Note that the motors are labelled as FOCUS, IRIS, etc.
3 Plug the motors into the RECEIVER unit.
The motor port that the motors attach to isn't important. The motors will begin
calibrating.
4 Put a Canon LP-E6 battery in the Hand Unit and hold down
the PWR button.
Camera Run/Stop
1 Connect the appropriate Run/Stop cable from the CAM
port on the Receiver to your Camera.
2 Enter the Controller’s MENU, Select CAMERA, then select
which camera you have connected.
3 You can now Run/Stop the camera with the REC button.
3