User guide

M e n u T r e e
does not have an 5 pin AUX port, you will not have this menu.
MODE What function to assign to the AUX PORT?
OFF Disable the AUX port.
WIRED
Configure AUX port for WIRED MODE (i.e. wire from Controller ->
Receiver to bypass radio).
KNOB You have a KNOB or THUMBWHEEL attached to the AUX PORT.
ROCKER You have a ROCKER attached to the AUX PORT.
FORCE You have a FORCE SENSOR attached to the AUX PORT.
AXIS
Which axis to control with the attached AUX input device? N.B. This
does not apply if you are in WIRED MODE.
FOCUS
IRIS
(etc.)
MODE B As “Mode” above, but for input axis B (for use with splitter).
AXIS B As “Axis” above, but for input axis B (for use with splitter).
BUTTONS
BT 1 Assign a function to the physical UP button.
BT 2 Assign a function to the physical DOWN button.
BT 3 Assign a function to the physical SET button.
BT 4 Assign a function to the physical POWER+UP button combination.
BT 5 Assign a function to the physical POWER+DOWN button combination.
BT 6 Assign a function to the physical POWER+SET button combination.
ADVANCED Advanced functions for debugging and technician use only.
SERIAL Change the Serial # of the handset (not recommended).
FAC RESET
Take the CONTROLLER back to factory default settings. This DOES NOT
roll back the firmware version. It also does not change the settings stored
inside the motors (class, response, etc.)
DEBUGGING Raw read-outs to use for diagnosing issues.
RADIO Enable/Disable the radio. (Radio is automatically disabled when wired
28