User guide
M e n u T r e e
inside the motor.
SCREEN Change OLED settings
HIGH Full brightness for daytime. Status LED also bright.
LOW Low brightness for night/indoor. Status LED dim.
OFF OLED disabled (menu is still active). Status LED dim.
FLIP KNOB Short cut which flips (reverses) the MAIN KNOB rotation.
WIRELESS Settings for CONTROLLER MK3 generation (RF2).
CHANNEL #1 - 13
WIRELESS Settings for CONTROLLER MK3.1 generation (RF3).
RANGE Select Controller transmission power.
USA MAX Maximum Range legal in USA.
EU MAX Maximum Range legal in EU and most of the world.
MED Medium Range (best balance of range and battery life).
LOW Required when very close to camera.
RESET Force the wireless module to reboot. Debug feature, to be removed.
INPUTS Configure the physical knobs/ slider on the controller.
AXIS Which INPUT (Knob, Slider) should control which AXIS (Focus, Iris) ?
FOCUS KNB→ The FOCUS axis is controlled by KNB, i.e. main knob.
IRIS -> SLI The IRIS axis is controlled by SLI, i.e. the slider.
etc.
FLIP Flip the direction of INPUTS. i.e. make the lens rotate in REVERSE.
KNOB = Y The main knob is set to FLIP mode (reverse).
SLIDER = N The slider is not set to flip.
etc.
FILTER This menu is currently inactive.
RECAL KNOB
Reconfigure the physical stops for the MAIN KNOB. If you are unable
to reach the end of the lens travel, run this function.
AUX Configure the auxiliary port on the RECEIVER. Note, if your Receiver
27