User guide

U p d a t i n g F i r m w a r e s
Updating The Receiver
1. Run the Program.
2. Make sure the receiver is not powered and that no motors are
attached.
3. Connect the USB cable from the Receiver to your computer. The
Receiver should power up.
4. The program will now detect and connect to the Receiver. You
should see, “Connected to Device” in the program.
5. In the “Which Device to Update” section, select Receiver from the
drop down menu.
6. In the “Firmware” section there should only be one firmware to
select from the drop down.
7. Click the “Update Device” button.
Note: If you connect the Receiver to a computer without having the Firmware Updater
Application already running, the Receiver will boot into “normal” operation and not be
visible as a USB device. Always run the Firmware Updater application BEFORE attaching
the Receiver to the computer.
Note: The first time you connect your device, your operating system may install HID
“Human interface device” drivers and require you to restart your computer. This is
normal.
22