User guide

A u x P o r t s

Setting the AUX PORT's Mode

The AUX port must be in the correct mode. The setting is remembered after

power-cycling.

To configure the AUX PORT, use the CONTROLLER. Enter the MENU, then

select AUX.

AUX

Configure the auxiliary port on the RECEIVER. Note, if your Receiver

does not have an 5 pin AUX port, you will not have this menu.

MODE What function to assign to the AUX PORT?

OFF Disable the AUX port

WIRED

Configure AUX port for WIRED MODE (i.e. wire from Controller ->

Receiver to bypass radio)

KNOB You have a KNOB or THUMBWHEEL attached to the AUX PORT.

ROCKER You have a ROCKER attached to the AUX PORT.

FORCE You have a FORCE SENSOR attached to the AUX PORT.

AXIS

Which axis to control with the attached AUX input device? N.B. This

does not apply if you are in WIRED MODE.

FOCUS

IRIS

(etc.)

MODE B As “Mode” above, but for input axis B (for use with splitter)

AXIS B As “Axis” above, but for input axis B (for use with splitter)