User guide

M K 3 . x C o n t r o l l e r
Operation
1 Power On
Hold down the POWER button for 2 seconds to turn the unit ON / OFF.
2 Camera Run/ Stop
Press the REC button to start recording. Press REC again to stop recording.
Note: you must use the correct Run/Stop cable for your camera and select the correct
option in MENU / CAMERA.
3 Status LED
OFF – Unit is OFF ORANGE – No Connection GREEN – Unit is Connected
BLUE – Wired Mode RED – Camera Running PURPLE – Please Wait
4 PC Mode / Bootloader
Turn off the Controller. Hold down the SET button. Keep SET held, and also
hold down the POWER button. The Status LED will go Orange, and the screen
display: “PC MODE”. You can now connect the controller to a PC and it will
show as a USB device.
5 Battery / Power
The Controller takes a CANON TYPE LP-E6 BATTERY, as used in the Canon 5D,
7D, etc.
It can also run from the MICRO USB connector (5V). Please note, minimum is
approx 4.65V- some laptops, etc. don't provide quite enough voltage.
6 Factory Reset
Enter the MENU / ADVANCED / FAC RESET.
Short-cut: You can also hold POWER and press MENU.
10