Operating instructions

15
It’s Under Control
®
CHAPTER 3 | OPERATION
GETTING STARTED
The T4 is turned-on by simply sliding the power switch (located in the
battery compartment) into the ‘ON’ position. If the unit shows no activity,
the battery may need to be re-charged.
After power is applied, the T4 will take approximately ten seconds to load
the operating system, the application software, and the user program. This
long delay only occurs from a power-down state. During normal use the T4
turns-on instantly from its power down mode.
After powering down, the T4 is turned-on by touching any area of the
display or any keypad button. If the tilt sensor is enabled, picking up the
unit will also turn it on.
The power switch should be in
the ON position, and the battery
connector should be attached.