Operating instructions
Multi-Room Audio Keypad
RKM-1
14
DISPLAY LENS FILM INSTALLATION
The display can be altered to closely match the audio sources that
will be controlled by changing the lens lm that is used. A sheet with
ten lens lms are included with the RKM-1, each with different source
congurations.
NOTE: The RKM-1 ships with the Display Lens uninstalled. For rst-time
installation, skip to step 3.
1. Remove front plate by pressing a screwdriver into slots at bottom of
RKM-1 to release tabs:
2. Place screwdriver in groove on backside of front plate and press down
to pry display lens off:
3. Choose lens lm that most closely matches the
audio sources in your system.
4. Align lm inside the raised edge on backside of
display lens (letters appear to be reversed from
the backside so they appear correct once the lens
is installed).
5. Once aligned - press lm rmly into place.
6. Snap display lens into front plate, paying attention
to the correct orientation.
7. Snap front plate on to RKM-1 enclosure.
Slots
Groove
Display Lens
CHAPTER 3 | INSTALLATION AND OPERATION
Front Plate (Backside)
Lens Film
Display Lens (Backside)