User manual

RT USB3000 Technical Description and User Manual Rev. 4.1. 11 of 18
The procedure of connecting the RT USB3000 device is as follows:
1. If you are going to use the external power supply, connect the power supply from the
delivery set of the device to AC network and to the Power Supply Port of the device.
2. Connect the device to the PC via a USB cable. At this the “Link” LED should turn on. When
the device is connected for the first time, driver installation might be required. For further
information see
Connecting the device to the PC for the first time.
3. Connect the signal sources to the device — see
Connecting to the object.
The procedure of disconnecting the RT USB3000 device is as follows:
1. Disconnect the object (signal sources) from the device.
2. Disconnect the device from the PC.
3. Disconnect the power supply from the AC network (if it was used).
5.1. Connecting the device to the PC for the first time
When the RT USB3000 device is connected to a Windows PC for the first time, it is necessary to
specify the location of the device driver.
Before connecting the device to the PC for the first time you should first insert the included CD
into the CD-ROM drive of your PC and only then connect the device to the PC via a USB cable.
As a rule, having detected a new device, Windows starts the Found New Hardware Wizard. In this
case you should follow its instructions, choosing not to go to the Windows Update site and specifying
the “\DRV” folder on the included CD as the location of the driver.
Windows might not start the Found New Hardware Wizard automatically, returning a driver error
message in the notification area (in the right bottom corner of the screen):
In this case you should start the Device Manager. In different Windows OS versions the Device
Manager is started differently. For example, in Windows 7 it can be started by right-clicking the
Computer icon, then – Properties, and then – Device Manager.