User`s manual

95
Solid State Disk Utility (SSD.EXE)
The Solid State Disk utility program (SSD.EXE) allows you to program applications into 12 volt
Flash or conventional EPROMs for use in a Conventional Solid State Disk. It is supplied on the cpu-
Module utility floppy disk. Use of the program is described below.
Available Options
The SSD program screen is divided into two areas:
• the upper part contains user-selectable fields
• the lower part contains help messages and displays program output
Once you make selections, you can:
• start executing the program, by pressing the {S} key
• quit the program, by pressing the {Q} key.
Field Selection
You can make selections using the keys listed in the following table.
Contents of the Fields
The following is a list of selectable fields in the SSD program:
SSD Active Keys
Key Function
Ð selects next field
Ï selects previous field
{TAB} selects next field to the right or first field of next line
Í
selects next value in field
Î selects previous value in field
Selectable Fields
Field Active keys Selections
Binary Files
Í
Î Enables creation of binary files (EPROMx.BIN)
needed to program EPROMs for the Solid State
Disk.
Selections:
• Construct
• None
The program creates the .bin files in the directory
from which it is run. When working with a single
floppy do not enable the Construct option.