User`s manual

Default Configuration

Jumper JP5 is used to ensure that you can always get into setup, even if you disable the keyboard

and display. The jumper should not be installed for normal operation. When JP5 is installed it forc-

es the cpuModule to ignore all user setup information and boot with the default values outlined in

the following table. With JP5 installed you can do two things:

• boot the cpuModules from a floppy disk

• press <Del> to run the Setup program and re-configure the cpuModule

This procedure is described in more detail at the end of this chapter.

Highlights of Default Setup

Item Setting Controlled by:

Boot device Floppy Setup

SSD size/type None Setup + jumpers

Memory 16MB Setup

Video EGA/VGA Setup

Floppy Drive 1 1.44M 3.5" Setup

Floppy Drive 2 Not installed Setup

Hard disk Not installed Setup

Failsafe Boot

Rom

Enable Setup

NOTE!

When Fail Safe Boot ROM is enabled the cpuModule will boot to the

Book Block Flash exclusively.