User`s manual

100
Jumpers
The figure below shows the locations of the jumpers used to configure the cpuModule. To use the
figure, position the module with the PC/104 bus connector at the six o'clock position and the com-
ponent side facing up. The table below lists the jumpers and their settings.
Jumper Use
JP 1 6-pin jumper.
Used with JP7 to configure first SSD socket.
Factory Default: (position 1-2)
JP 2 6-pin jumper
Used with JP8 to configure second SSD socket.
Factory Default: (position 1-2)
JP 3 2-pin jumper
Used to enable/disable 120 ohm termination resistor on first serial port.
Factory Default: Open (no termination)
JP 4 2-pin jumper
Used to enable/disable 120 ohm termination resistor on second serial port.
Factory Default: Open (no termination)