User manual

Page 46
501 SE Columbia Shores Boulevard, Suite 500, Vancouver, Washington 98661, USA l [phone]
SmartRG Inc. Propriety and Condential. All Rights Reserved. Copyright © 2014 smartrg.com
Field Name Description
Filter Name A free-form text eld. Enter a descriptive name for this lter.
IP Version Version IPv4 applies by default. IPV6 can be alternately selected.
Protocol [TCP/UDP, TCP, UDP, or ICMP] Select the protocol to be associated with this incoming lter.
Source IP address [/prex length] Enter source address for rule.
Source Port (port or port:port) Enter source port number or range.
(Destination port numbers xxxxx:yyyyy).
Select All checkbox Check as applicable to apply rule to all interfaces.
First WAN interface (e.g. pppoe
based) checkbox
Last WAN interface (e.g. ipoe
based) checkbox
Check each as applicable to effect rule on specic WAN interface(s). WAN interface(s)
available for selection will be those congured in Routing mode and with rewall enabled.
First LAN interface checkbox
Second LAN interface (as applica-
ble) checkbox
Check each as applicable for desired rule.
Bridged Interface checkbox Check as applicable for desired rule.
The individual elds on this screen are dened as follows:
MAC Filtering
Your SmartRG gateway can block or forward packets based on the originating device. This MAC ltering feature is available only
in Bridging mode. For other modes, similar functionality is available via IP Filtering.
After selecting Advanced Setup -> Security -> MAC Filtering from the left sidebar, alter the Policy to FORWARD or BLOCKED as
desired.