User manual
Page 35
501 SE Columbia Shores Boulevard, Suite 500, Vancouver, Washington 98661, USA l +1 360 859 1780
SmartRG Inc. Propriety and Condential. All Rights Reserved. Copyright © 2014 smartrg.com
IP Over Ethernet
The next WAN Service variant is IP over Ethernet.
After selecting Advanced Setup -> WAN Service from the left navigation bar, click the Add button. A progression of several screens
will follow. Advance to the next after completing the required elds using the Next button appearing near the bottom of each
screen.
First, select the Layer2 interface to use for the WAN service.
Click the Next button to advance to the next step.
Next, select the type of WAN service you wish to create.
For this example choose IP over Ethernet.
Click Next after completing the necessary elds.
The individual elds on this screen are dened as follows:
Field Name Description
WAN service type [PPP over Ethernet PPPOE, IP over Ethernet IPoE, Bridging]
Enter Service Description Enter a name to describe this conguration.
Network Protocol Selection [IPV4 Only]
[IPV4&IPV6] (Dual Stack) – IPV4 and IPV6 running concurrently.
[IPV6 Only]
Note: When selecting IPV4&IPV6 or IPV6 the subsequent options presented will change ac-
cordingly.