User manual
Default IP Address – 192.168.0.100
Figure 4-10 Real Time Automation IPSetup screen
5. Click on Search Again.
The 460 Gateway units on the network display. If the crossover cable is connected
directly to your computer instead of to a hub, the 460 Gateway is the only one that
displays.
Note: If you don’t see the 460 Gateway on the right, the unit is not accessible, and you
need to look at connections to hub, router, switches, etc.
6. Change the IP, Network Mask, GateWay or DNS fields according to your network
requirements. Leave Baud rate at the default value.
7. Highlight (click on) the unit to program on the upper right side of the screen, and click
Set. After you have changed any other IP or subnet addresses (if necessary), click on
Close.
8. Close the Tools folder and remove the User Manual and Tools CD.
TheRealTimeAutomation460Gatewaywebsite
If you do NOT have the User Manuals and Tools CD that was shipped with the 460 Gateway,
use the following steps to change the IP or subnet address.
1. Connect one end of an Ethernet crossover cable to the 460 Gateway and the other end to
the RJ45 connector on your computer or to a hub/switch on the same subnet. A red
Ethernet crossover cable was shipped with the 460 Gateway.
2. Insert the power connector to the 460 Gateway, and then plug the power cord into a
power source.
3. Your computer needs to be on the same subnet as the 460 Gateway. The unit’s default IP
address is 192.168.0.100. Therefore your computer’s IP address must be set at
192.168.0.xxx, where xxx is any number that is not being used by any other device on
your network.
If your computer is using a dynamic IP address (typical), you need to change it to a static
192.168.0.xxx address. Use the following steps to change your computer’s IP address.
a. Go into your Network Setup.
b. Select Internet Protocol (TCP/IP).
c. Click on Properties.
d. Click Use the following IP address.
e. Type in 192.168.0.10 (the last two digits are an example and can be any number
as long as it is not being used). The Subnet mask should default to 255.255.255.0.
Click OK.
460 Gateway User Manual Page 67