User manual

Default IP Address – 192.168.0.100
Changing IP or subnet addresses
After the 460 Gateway is setup and installed, you can still change IP or subnet addresses using
one of two methods. The easiest way involves using the IPSetup.exe tool on the User Manuals
and Tools CD shipped with the 460 Gateway. However, if you no longer have the CD that came
with the 460 Gateway, you can still change IP or subnet addresses using the Real Time
Automation 460 Gateway web site.
TheIPSetup.exe
If you have the User Manuals and Tools CD that was shipped with the 460 Gateway, use the
following steps to change the IP or subnet address. You can run this tool from your desktop, as it
does not install any files.
1. Connect one end of an Ethernet crossover cable to the 460 Gateway and the other end to
the RJ45 connector on your computer. A red Ethernet crossover cable was shipped with
the 460 Gateway. (Or, you can use a regular Ethernet cable connected to a hub or subnet
with the 460 Gateway.)
2. Insert the power connector to the 460 Gateway, and then plug the power cord into a
power source.
3. Insert the CD into the CD-ROM drive on your computer. Double-click on the Tools
folder.
Three tools display.
For Your Information: If you no longer have the CD that shipped with the 460
Gateway, download the IPSetup.exe at http://www.rtaautomation.com/support
from the Real Time Automation’s website.
4. Double-click on IPSetup.
The Real Time Automation IPSetup screen displays. See Figure 4-10.
460 Gateway User Manual Page 66